Module: Test And Reset

Table of Contents

• TestAndReset Module Documentation
• Introduction
• Configuration Options
  • Example

TestAndReset Module Documentation

Introduction

The TestAndReset module allows end user to have visual and/or audio feedback when presenting a test card. It also allow the user to reset Leosac configuration to its factory default.

Note

This module is only able to watch module that sends SIMPLE_WIEGAND as auth-source data format.

Configuration Options

This is a module that watch input device and check for preconfigured reset/restart card.

Options	Options	Options	Description	Mandatory
test_buzzer			Device (beeper) to control when test card is read	NO
test_led			Device (led) to control when test card is read	NO
run_on_start			Should we beep/blink when the module starts ?	NO (defaults to true)
promisc			Listen to all event to watch for reset card.	NO (defaults to false)
reset_card			Wiegand ID of reset card. Only useful if promisc is true.	YES if promisc is true.
devices			List of devices to watch for	NO
—>	device		Watch for event sent by this device	YES
—>	—>	name	Name of the device	YES
—>	—>	reset_card	Content / number of the card	NO
—>	—>	test_card	Id of the card that trigger test led/beep stuff	NO

About promisc mode: It will listen to everything on the message bus to try and detect the reset card. This comes at a little performance cost because we watch way more message than needed. However, this has the advantage of working without specifying a source device, which may be helpful when synchronizing configuration.

Example

This is a example of a possible configuration for the TEST_AND_RESET module:

<module>
    <name>TEST_AND_RESET</name>
    <file>libtest-and-reset.so</file>
    <level>101</level>
    <module_config>
        <run_on_start>false</run_on_start>
        <test_buzzer>my_buzzer</test_buzzer>
        <test_led>my_blinking_led</test_led>
        <devices>
            <device>
                <name>MY_WIEGAND_1</name>
                <reset_card>40:a0:83:80</reset_card>
            </device>
        </devices>
    </module_config>
</module>